4.3 Operation 4.3
CHANGING THE BLADE HOLDER
Before removing a blade holder make sure the blade has been removed or guarded
(dependent upon type).
Loosen both of the small knurled knobs
A
by about two turns, raise the blade holder to
align the knobs with holes in the blade holder then pull towards you to release. Reverse
the procedure to attach a blade holder to the cutting head.
The Rotary blade holder has a special safety device to ensure the blade is guarded
before the holder can be removed, this is covered in the Rotary Cutter section.
A
A
To Next Page
Loading...
