10:00
Quick Start Guide
Installing Your
Keenetic Carrier DSL
For technical support or other information, please visit
help.keenetic.com
AC1200 Dual Band Mesh Wi-Fi VDSL2/ADSL2+ Modem
Router with 4-Port Smart Switch and USB Port
Model: KN-2111
Welcome to
Your Keenetic
3
45
1
Сonnect a mobile device to your Keenetic router
via Wi-Fi. The default Wi-Fi name (SSID) and Wi-Fi
password are printed on your Keenetic device’s
back label along with a QR code that will
automatically connect your mobile device
to the Keenetic device’s Wi-Fi when scanned.
Alternatively, сonnect a computer to any gray
Ethernet port on your Keenetic device using
the included Ethernet cable.
Once connected, an Initial Setup Wizard window
will appear on your mobile device / computer.
If the Wizard does not appear, in your browser
go to my.keenetic.net.
Note: If the Initial Setup Wizard still doesn’t
appear, please refer to the Frequently Asked
Questions section.
In the Initial Setup Wizard window that appeared,
select the configuration option.
To create a new network and connect it to the
Internet, choose the appropriate connection type
and follow the setup instructions.
To extend an existing network and add this
Keenetic device as a Wi-Fi extender, choose the
‘To switch to Wi-Fi Extender Mode’ option and
follow the setup instructions.
2
Connect your Keenetic
Peak (hereinafter ‘Keenetic
device’, 'Keenetic router')
to a power source. Check
that both the Status LED
C and Wi-Fi LED D are
illuminated and not
blinking.
Position the Wi-Fi
antennas vertically.
1432
0
DSL
To Next Page
Need help?
General
