Keiser M SERIES Assembly And Operation Manual

M5i | M5 STRIDER ELLIPTICAL
18
87
To receive and download workout information from your M5i to any Bluetooth
®
smart device, a Machine ID number
(displayed as “bid”) is required. Perform the following one-time procedure to set both the “bid” and the Trip Unit (miles
or kilometers) at once. NOTE: Steps 1 through 7 must be completed within one minute.
Begin with the computer off and pull
Resistance Lever all the way down
towards you. This is GEAR “1” position.
Pedal 1 full revolution to change the
TIME value to “2”.
Shift the Resistance Lever from top to
bottom (GEAR “88” to GEAR “1”) for a
total of 6 times.
Pedal 1 full revolution to change the
TIME value to “1”.
Shift the Resistance Lever to GEAR “19”
for Miles, or GEAR “21” for Kilometers.
Conrm the Trip Unit setting:
“USA” = miles
“EURO” = kilometers
For Bluetooth
®
smart setup, continue
to Step 9. Otherwise, allow the
computer to shut down before use
(estimated time, one minute).
NOTE: If Steps 1–7 are not completed
within one minute, allow the computer
to shut down (estimated time, one
minute) and restart the procedure.
Shift the Resistance Lever to GEAR “21”
for Miles, or GEAR “19” for Kilometers.
Pedal 1 full revolution to change the
TIME value to “3”.
Set Machine ID (“bid”):
increases “bid” number
decreases “bid” number
Set the “bid” number to any number
between 1 and 199.
To hold the “bid” number, put ------ to
any GEAR number between 8 and 16.
NOTE: The computer must shut down
to save the “bid” number and exit the
Bluetooth
®
smart set up mode. Allow the
computer to shut down (estimated time,
one minute) before use.
1 2 3
4 6
9
GEAR 1 to 7
DECREASES
“bid” number
GEAR 8 to 16
HOLDS
“bid” number
GEAR 17 to 24
INCREASES
“bid” number
5
M5i BLUETOOTH
®
smart
1x
6x
1x
GEAR “88”
GEAR “1”
Machine ID
“bid”
Trip Unit

Keiser M SERIES Specifications

General

Brand	Keiser
Model	M SERIES
Category	Fitness Equipment
Language	English