Keiser M SERIES Assembly And Operation Manual

M5i | M5 STRIDER ELLIPTICAL
22
WARNING: Install batteries correctly (+/-). Do not disassemble or dispose of batteries in re.
Check local government guidelines for battery disposal/recycling in your area. Battery leakage is
extremely caustic and contact with bare skin should be avoided. Follow battery manufacturer’s
recommendations for care and use.
“LO-BA” will appear on the computer to indicate that the batteries are low and need replacement. To replace the batteries:
1. Remove the battery compartment screw using a #1 Phillips screwdriver (refer to Figure 15).
2. Remove the two AA batteries (follow manufacturer's recommendations for handling, maintaining, and disposing of batteries).
3. Install two new AA batteries observing the correct polarity (see +/- marking inside the battery compartment). R6 (Zinc-Carbon)
or LR6 (Alkaline) type batteries are acceptable. Do not use FR6 (Lithium) or similar type batteries.
4. Replace the battery compartment cover onto the computer housing and reinstall the screw.
All M Series equipment is factory calibrated. There is no need to calibrate. If a component associated with the resistance
mechanism or computer has been replaced, contact Keiser Customer Support for the calibration procedure (see back page
for contact information).
COMPUTER BATTERY REPLACEMENT
M SERIES CALIBRATION
NOTE: Upon end of life of your Strider Elliptical, contact Keiser Customer Support for handling direction (see back page for contact
information). Be sure to follow your local government guidelines for battery disposal/recycling.
Figure 15. Strider Elliptical Battery Replacement

Keiser M SERIES Specifications

General

Brand	Keiser
Model	M SERIES
Category	Fitness Equipment
Language	English