p04.
M3i INDOOR GROUP CYCLE
1. Carefully remove the cycle from the box.
2. Carefully unwrap the cycle.
3. Layout all the cycle components and compare them to the “Parts List” on page 5.
4. Check that all parts are present and undamaged.
NOTE: If parts are missing or damaged contact your local dealer, distributor or Keiser Corporation Service
Department.
Thank you for purchasing Keiser’s premier M3i indoor cycle. Your new resistance system is a revolutionary way to
exercise providing a smoother, quieter, and more predictable workout.
The following tools are required to assemble the cycle but not supplied:
WARNING: Use caution when using a box cutter or other tool with a sharp blade to unwrap the
cycle. A sharp tool can cause damage to the seat, handlebar, or scratch the frame of the cycle.
INTRODUCTION
WEIGHT AND FOOTPRINT
TOOLS REQUIRED FOR ASSEMBLY
Total Weight
Qty
1
1
1
1
1
1
2
Qty
1
1
1
1
1
1
Description
Torque wrench (Minimum 45 Nm/35 ft-lb)
4 inch extension
15 mm open-end wrench
16 mm, or 5/8 inch open-end wrench
#2 Phillips screwdriver
15 mm crow foot
10 mm wrenches
Description
16 mm, or 5/8 inch crowfoot
5 mm Allen wrench
6 mm Allen wrench
Paste or spray wax (used to clean after
assembly)
Clean cloth
LPS #3 heavy-duty rust inhibitor
with straw
91 lbs (41.27 kg)
Length 60.5 inches (1537 mm) x Width 25.75 in (654 mm) M3i Footprint
ASSEMBLY
To Next Page
Loading...
