Keiser M3I - INSTALLING THE FLYWHEEL GUARD

p08.
M3i INDOOR GROUP CYCLE
1. Remove the two Allen screws and washers from the base
frame, refer to Figure 5. Do not discard the screws. They
will be used to mount the ywheel guard.
2. Place the open end of the ywheel guard over the
mounting stud located on the frame of the cycle, refer to
Figure 6.
3. Swing the guard over the ywheel, refer to Figure 7.
INSTALLING THE FLYWHEEL GUARD
Figure 4. Flywheel and Hubcap Installation
Figure 5. Remove the Allen Screws
Figure 6. Flywheel Guard Placement Figure 7. Center Flywheel Guard Over Flywheel
NOTE: When installing and centering the guard, try to avoid touching the ywheel with the guard.
3. Align the holes of the ywheel with the holes of the hub.
NOTE: The ywheel should be ush against the hub.
4. Install the hubcap:
a) Align the holes of the hubcap with the holes of the
ywheel, refer to Figure 4.
b) Hold the ywheel in position.
c) Use the ve, M6x1x20 SS socket head cap screws
(supplied) and a 5 mm Allen wrench and tighten
the screws.
d) Be sure the ywheel is ush against the face of the
hub. Spin the ywheel to make sure the it runs true
and straight (no wobbling).