Ch
Sets the MIDI channel to output the CC messages on.
Bank
Outputs values as MIDI bank select messages. The following options are available when Bank is
selected:
MSB
Sets the MSB of the bank message.
Ch
Sets the MIDI channel to output the bank select messages on.
Note: Bank Select messages are 14-bit resolution (a range of 0-16383), as opposed to the standard 7-
bit MIDI message (range 0-127). This is accomplished by using two separate messages: a MSB (most
signiÞcant bit) and an LSB (least signiÞcant bit). With SoftStep, values passing through the modline will set
the LSB of the bank message Ñ!the MSB must be Þxed at a speciÞed value (using the MSB option).
Program
Outputs values as MIDI program change messages. The following options are available when
Program is selected:
Ch
Sets the MIDI channel to output the program change messages on.
Pitch Bend
Outputs values as MIDI pitch bend messages.
•
0 = full bend down
•
63 = center (no bend)
•
127 = full bend up
The following options are available when Pitch Bend is selected:
Ch
Sets the MIDI channel to output the pitch bend messages on.
MMC
Used to send MIDI Machine Control (MMC) messages. The following options are available when
MMC is selected:
Appendix 61
チャンネル(Ch)
CC メッセージを出力するチャンネルを設定します。
バンク(Bank)
MIDI バンク・セレクトのメッセージを出力します。バンクを選択すると、以下のオプションが利用
できます:
MSB
バンク・メッセージの MSB を設定します。
チャンネル(Ch)
バンク・セレクト・メッセージを送信する MIDI チャンネルを設定します。
△参考:バンク・セレクト・メッセージの解像度は、標準的な MIDI メッセージが 7 ビット(0 〜 127)
なのに対して、14 ビット(0 〜 16383)です。これは MSB(MostSignificantBit:最上位ビット)と
LSB(LeastSignificantBit:最下位ビット)という、2 つの独立したメッセージを使用することで実現
しています。SoftStep では、モッドラインを通過する値はバンク・メッセージの LSB を設定します
――MSB は(MSB オプションで)特定の値に固定しておかなければなりません。
プログラム(Program)
MIDI プログラム・チェンジ・メッセージを出力します。プログラムを選択すると、以下のオプションが
利用できます:
チャンネル(Ch)
プログラム・チェンジ・メッセージを送信する MIDI チャンネルを設定します。
ピッチ・ベンド(PitchBend)
MIDI ピッチ・ベンド・メッセージを送信します。
●0=フル・ベンド・ダウン
●63=中点(ベンド無し)
●127=フル・ベンド・アップ
ピッチ・ベンドを選択すると、以下のオプションが利用できます:
チャンネル(Ch)
ピッチ・ベンド・メッセージを送信する MIDI チャンネルを設定します。
MIDI マシン・コントロール(MMC)
MIDI マシン・コントロール・メッセージを送信します。MMC を選択すると、以下のオプションが利用
できます: