Keithley 3700 Series User Manual

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-184 3700AS-901-01 Rev. D/June 2018
dmm.limit[Y].clear()
This function clears the results of the limit test defined by Y.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
dmm.limit[Y].clear()
Y
Limit number: 1 or 2
Details
Use this command to clear the test results of limit Y when the limit auto clear option is turned off. Both
the high and low test results are cleared.
To avoid the need to manually clear the test results for a limit, turn the auto clear option on.
Example
dmm.func = "twowireohms"
dmm.limit[2].clear()
Clears the test results for the high and low limit 2
for two-wire ohms.
Also see
dmm.configure.recall() (on page 11-165)
dmm.configure.set() (on page 11-166)
dmm.limit[Y].autoclear (on page 11-183)
dmm.limit[Y].high.fail (on page 11-187)
dmm.limit[Y].low.fail (on page 11-191)
dmm.limit[Y].enable
This attribute enables or disables a limit test on the measurement from the selected measure function.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Reset
DMM reset
Recall setup
Create configuration script
Save setup
0 (dmm.OFF)
Usage
value = dmm.limit[Y].enable
dmm.limit[Y].enable = value
value
Limit Y testing:
▪ Disable: dmm.OFF or 0
▪ Enable: dmm.ON or 1
Y
Limit number: 1 or 2

Keithley 3700 Series Specifications

General

Brand	Keithley
Model	3700 Series
Category	Multimeter
Language	English