Keithley 3700A Series Reference Manual

Series 3700A System Switch/Multimeter Reference Manual Section 11: TSP command reference
3700AS-901-01 Rev. D/June 2018 11-21
Example
reset()
testData = dmm.makebuffer(1000)
testData.collectchannels = 1
dmm.nplc = 0.5
dmm.range = 0
dmm.configure.set("Dcv_100mV")
dmm.setconfig("slot2", "Dcv_100mV")
scan.create("2035:2040")
scan.execute(testData)
print(testData.channels[1])
printbuffer(1, 6, testData.channels)
This example creates a reading buffer named
testData, configures the buffer to collect
channel data, sets and saves the DMM
configuration, creates a scan list, and then
runs the scan.
The print() command then outputs the first
measurement channel.
Output:
2035+
The printbuffer() command then outputs
the channels for measurements 1 to 6 in the
reading buffer.
Output:
2035+, 2036+, 2037+, 2038+, 2039+,
2040+
Also see
bufferVar.clear() (on page 11-21)
bufferVar.collectchannels (on page 11-23)
Reading buffers (on page 6-7, on page 6-1)
bufferVar.clear()
This function empties the buffer.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
bufferVar.clear()
bufferVar
The reading buffer
Details
This function clears all readings and statistics from the specified buffer (for example, time, status,
channels, and units) from the specified buffer.

Keithley 3700A Series Specifications

General

Brand	Keithley
Model	3700A Series
Category	Multimeter
Language	English