Kelly KLS-M/N Brushless Motor Controller User’s Manual V 2.5
Figure 10: RS232 Interface on 4pin connector to RS232 converter
Figure 11
：
SM-4P connector for communication interface on KLS-M controller
3.3 Installation Check List
Before operating the vehicle, complete the following checkout procedure. Use buzzer code
as a reference as listed in Table 1.
Caution:
• Put the vehicle up on blocks to get the drive wheels off the ground before beginning
tests.
• Do not allow anyone to stand directly in front of or behind the vehicle during the checkout.
• Make sure the PWR switch and the brake is off
• Use well-insulated tools.
•
Make sure the wire is connected correctly
To Next Page
Loading...
