Kelly KLS-D Brushless Motor Controller User’s Manual V 1.5.02
Non-zero throttle on
direction change
Controller won’t allow a direction change unless the
throttle or speed is at zero. Fault clears when throttle
is released.
Regen or Start-up
over-voltage
Motor drive is disabled if an over-voltage is detected
at start-up or during regen. The voltage threshold
detection level is set during configuration.
1. Incorrect or loose wiring or a damaged hall sensor.
2. Also be caused by incorrect hall angle
configuration (60 degree or 120 degree)
Motor temperature has exceeded the configured
maximum. The controller will shut down until the
motor temperature cools down.
Customers may read error codes in PC software or Android Tablet
Contact Us:
Kelly Controls, LLC
Home Page:
http://www.KellyController.com
E-mail:
Sales@Kelly-Controls.com
Phone:
(01) 224 637 5092
To Previous Page
Loading...
Need help?
General
