6. LOCATION GUIDANCE AND INSTALLATION
Unpacking KEC and KMe
1. Remove the box/crate packaging
2. On most KEC units remove the draintray by removing the four fixings and then fit the hexagonal drain connection and
gasket into the hexagonal well inside the draintray. Hand tighten this assembly using the knurled nut on the outside.
When the cooler is in position ensure that the drainpan is dropped down into the operating position before tightening
its fixings. For the KME units will have a cable tie fixing the draintray along the side of the unit
3. Place into position using the location guidance.
To Next Page
Loading...
