Kemppi WELDFORCE KWF 200S User Manual

WeldForce KWF 200S / 0541 – 17
© KEMPPI OY
R61
R63
R20
R61
R10, RMT10
R63 R61
MIG Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Setting for voltage:
10 V...max. voltage of power
source (35...46 V)
Memory Channel selection: 1...5 corresponding
to settings 1, 4, 6, 8, 10 of knob
Fine adjustment for arc
length:1...10
SYNERGIC MIG Setting for power (wire feed speed):
according to wire min. ... max.
Fine adjustment for arc length:
1...10
MMA Setting for power:
10 A ... max. power of power source
NO OPERATION
R61 RMT 10 remote control unit for
PMT/WS gun
MIG Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Memory Channel selection: 1...5 corresponds
in the R10 settings
1, 4, 6, 8, 10 of knob
Channel selection 1 ...5
SYNERGIC MIG Setting for power (wire feed speed):
according to wire min. ... max.
Setting for power (wire feed speed)
according to wire min. ... max.
(see page 18, part 10)
MMA Setting for power:
10 A...max.power of power source
NOTE!
RMT10 NO OPERATION
4. OPERATIONS OF REMOTE CONTROL UNITS IN
KWF WIRE FEED UNIT

Kemppi WELDFORCE KWF 200S Specifications

General

Brand	Kemppi
Model	WELDFORCE KWF 200S
Category	Welding System
Language	English