The attached
hose swivels to
make cleaning
easier in every
direction, swivel.
Remove the
hose from the
hose clip by
pulling
straight out.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
||l till
Remove the
Crevice telescoping
Tool
wand from
its storage
Telescoping position.
Wand
Remove the crevice tool from its storage
position in the wand, Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length. Turn the
locking ring to the LOCK position. Attach the
extension wand onto the open end of the
hose.
Lower_ Suction
! _.
_ LOC.mg Hlng I
Align the tabs on the extension wand with
the "J" slots in the hose, Push the wand into
the hose and twist to the right to lock.
To achieve maximum reach
with the attachments, add Hose.
the crevice tool to the
end of the wand by suction
inserting and twist- control
Slide
ing slightly. ",_
Wandx
The dusting
brushor the
combinaUon
brush maybe
attached
direcUy to the
wand or
placed on the
end of the crevice tool.
OPERATE SUCTION
NTROL SLIDE
Telescoping Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twist the suction control slide
to the open position, This will reduce suction
for ease of cleaning. SucUon
Control
The slide is Slide
located on the
telescoping wand,
close to the hose.
Note: Return suction control slide to the
closed position for normal cleaning.
When usingattachments, be careful not
to overextendthe stretch hose when
reaching.Trying to reach beyondthe
hose stretchcapability couldcause the
cleaner to tip over. Make sure the car-
pet/bare floorselector is inthe bare floor
position. Damage to the floor surface
may occur if the carpet setting isused.
To Next Page
Loading...
