Installation Instructions
For A-Kit 22"
Please read ALL instructions before installing. Two
people are recommended to install this product. If
a new electrical outlet is required, have the outlet
installed by a qualified electrician before instalFmg
unit. See #5 in Preliminary Instructions following.
WINDOW SASH SEAL
2,/4"LONG HEX HEAD SCREW
Preliminary Instructions
Do the following before starting to install unit.
See illustrations below.
1. Check window opening size - the mounting
parts furnished with this air conditioner are
made to install in a wooden sill double-hung
window. The standard parts are for a window
opening of 30" (711 ram) minimum to 42"
(1067 mm) maximum width. Open sash to a
minimum of 19" (483 mm). (FIG. 1)
2. Check condition of window - all wood parts
of window must be in good shape and able to
firmly hold the needed screws. If not, make
repairs before installing unit.
3. Check your storm windows - you will need
1/2" (13 mm) clearance below window stool.
If storm window frame does not allow the
clearance required, correct by adding a piece
of wood as shown in FIG. 2, or by removing
storm window while room air conditioner is
being installed. (continued)
FIG. I _SASH
T
19" MIN.
,:'M,,. l
STORMWINDOWFRAME
OR OTHER OBSTRUCTION
TOPANGLE
FOAMGASKET
WASHERHEAD
ASSEMBLY
SIDE RETAINER
SEAL-BOTi'OM RAIL TO UNIT
ASSEMBLY
(R_GH'0
LOCI_IUT
3/4"LONG_ BRACKET
FLATHEAD _
BOLT SILLANGLE
BRACKET
FIG. 2
STORM WINDOW FRAME
OR OTHER OBSTRUCTION
_SASH
T
19=MIN.
1/2"MIN 111/2" M_._1
IRED, ALONG
RE STOOL
FASTEN WITH TWO
NAILS OR SCREWS.
• 309000904 (9704)
1
To Next Page
Need help?
General
