Installing Your Air Conditioner
NOTE: These instructions describeinstallationin a typicalwood framed window with a wood SLIDE-BY sash,
or installation in a metal CASEMENT window. Modificationmay be necessary when installing in windows made
differentlythan those shown in these instructions.
A high window accessory kit is available for window heights upto 62" (1575mm).
TABLE OF CONTENTS
SUBJECT PAGE
MeetingElectricalRequirements 1
ElectricalConnection 2
PreparingFor Installation 2
InstallingUnitina SlidingWindow 4
AlternateWindowJambApplications 7
InstallingUnitina CasementWindow 8
Optional Mounting Kit 11
appliance.
i,i
Failuretofollow
I electrical shock,
Meeting Electrical Requirements
OBSERVE ALL LOCAL GOVERNING CODES
AND ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUNDING PRONG.
NOTE: If codes permit, and a separate
groundingwire is used; it is recommended that a
qualified electdcian determine that the grounding
path is adequate and not interrupted by plastic,
non-metallic gaskets, or other insulatii_gmaterials.
RECEPTACLE WIRING
Receptacle widng should be a minimum of 14
gauge, Use copper wire only. It is your responsibility
to provide proper and adequate receptacle widng,
installed by a qualified electdcian.
ELECTRICAL REQUIREMENTS
A 115 volt (103.5 minimum, 126.5 maximum), 60
Hertz, AC only, 15 ampere fused electdcal supply
isrequired. A time delay fuse or time delay circuit
breaker is a_sorequired. A separate circuit, serving
onlythis appliance, MUST be provided.
P/N309000903 (9708)
To Next Page
Need help?
General
