Kenmore Stratus DS1020 User Manual

- 10 -
3. To stop the vacuum cleaner, place the
power/speed switch in the OFF position.
NOTE:
When the vacuum cleaner is low
on battery power, the battery charging
indicator on the handle will flash. The
flashing will stop if the vacuum is fully
charged or is completely out of battery
power.
1. To start the vacuum cleaner, slide the
power/speed switch to the LOW speed
position. Once turned on, the battery
charging indicator will be lit.
2. To increase the speed and performance
of the vacuum cleaner, slide the power/
speed switch to the HIGH speed
position.
Power/Speed Switch
OPERATING INSTRUCTIONS
USING YOUR VACUUM CLEANER
Before vacuuming, check that the brushroll
is clear from any obstructions such as hair
or sharp objects to avoid scratching floors,
and that the dust cup is empty.
NOTE:
Use the low-speed setting for
cleaning hard floors, and low pile rugs.
The high-speed setting should be used for
cleaning plush rugs and carpets or when
additional cleaning power is required.
CAUTION
Moving parts! To reduce the risk of personal injury, DO
NOT touch the brushroll when vacuum is on. Contacting the
brushroll while it is rotating can cut, bruise or cause other
injuries. Always turn off before servicing. Use caution when
operating near children or pets.
CLEANING WITH THE HAND VACUUM
Easily clean messes on furniture, upholstery,
stairs and other hard-to-reach areas with
the included combination tool.
1. To remove the hand vacuum, press the
hand vacuum release button and detach
it from the main body.
Hand Vacuum
Release Button

Kenmore Stratus DS1020 Specifications

General

Brand	Kenmore
Model	Stratus DS1020
Category	Vacuum Cleaner
Language	English