34
Automatic save function
After 5 seconds of inactivity, the
ashgun will automatically save your
current settings for convenience.
To clear user settings and restore
factory default settings, hold down both
‘clear’ buttons simultaneously.
Flash lock
When the ash power is low, or another
reason is preventing the ash charge
from completing within 20 seconds,
the ash will enter a locked state. The
screen will display as per the diagram
(right), and a short buzzer will sound
(if audible alerts are switched on) to
remind the user to replace the battery
to resume normal use. If after replacing
the drained batteries with fully charged batteries, the ash still
cannot complete recharge within 20 seconds, please contact the
after sales service.
To Next Page
Loading...