32
Wireless optical ash
When using a built-in ash or an external ash connected to the
camera’s hotshoe as the MASTER with an additional SLAVE ash in
an indoor environment, light reecting off of walls and ceilings may
cause overexposure. Please adjust the angle of the ash heads as
needed.
S1 and S2 modes can be used outdoors up to a distance of 15m,
dependent on conditions.
Note: Please ensure there are no barriers between the MASTER and
SLAVE lights when using optical SLAVE modes. Also ensure that the
SLAVE unit is not in direct sunlight or other brightly lit environments
as this will impact on the ashgun’s ability to detect the MASTER
ash ring and trigger accordingly. If the speedash is in direct
sunlight, try turning the unit so that the sensor faces away from the
sun, and rotating the ash head to face the desired direction.
Audible alerts
Long press the backlight / function button to bring up the custom
functions menu. Press the up and down buttons to navigate to
Fn-14, then use the left and right buttons to toggle between 0 to
turn audible alerts on, and 1 to turn them off.
Alerts are as follows:
1. A long beep: When the sound stops, the ashgun is fully
recharged and ready to re again
2. Two short beeps: Unit has powered on and is ready to re
3. Three short beeps: Unit has powered off
4. Two long beeps: Flash recycle not complete
5. Five short beeps: Battery power level warning
6. Continuous beep: Unit overheating and locked. Switch off and
leave for 15 minutes to allow to cool
Backlight display
ON/OFF: Press the backlight / function button to toggle backlight on
and off.
After the unit has been inactive for 15 seconds, the backlight will
automatically switch off.
To Next Page
Loading...