kenro SPEEDFLASH KFL101 - Page 31

31
Multi lighting applications
Wireless optical instruction
By using 2 or 3 ash units in SLAVE mode you can full a number of
multi-lighting needs.
• Using 2 SLAVE units in separate wireless ash groups.
Set mode in SLAVE c or SLAVE n accordingly by pressing the ‘left
clear’ button.
Set channel to 1, 2, 3 or 4 (all units must be on the same
channel) by pressing the ‘zoom’ button until the channel number
symbol ashes and using the left and right buttons to select a
number.
Set each SLAVE unit in its own group (e.g. rst ashgun in group
A, second ashgun in group B) by pressing the ‘zoom’ button
until the group letter symbol ashes, then using the left and right
buttons to select a group.
Set the power output of each group to achieve the desired effect
Set the MASTER unit to [RATIO A:B] or [RATIO A:B C] (see page
23 for more information)
• Using 3 SLAVE units in separate wireless ash groups.
Set mode in SLAVE c or SLAVE n accordingly by pressing the ‘left
clear’ button.
Set channel to 1, 2, 3 or 4 (all units must be on the same
channel) by pressing the ‘zoom’ button until the channel number
symbol ashes and using the left and right buttons to select a
number.
Set each SLAVE unit in its own group (e.g. rst ashgun in group
A, second ashgun in group B, third ashgun in group C) by
pressing the ‘zoom’ button until the group letter symbol ashes,
then using the left and right buttons to select a group.
Set the power output of each group to achieve the desired effect
Set the MASTER unit to [RATIO A:B C] (see page 23 for more
information)
Before commencing shooting, press the test button on the MASTER
ash. If the SLAVE unit does not re, please check the ash position
and distance and adjust accordingly.
Note: If you are using [RATIO A:B], SLAVE group C will not re. If all
three SLAVE units are set to group A, they will all take the settings of
the MASTER ash.