Kentec Electronics Sigma XT Plus - Page 52

Kentec Electronics Sigma XT Plus

52 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

Man-1112 Sigma XT+_23 Page 52 of 52

*

Man

-

1112

*

Table of Contents

Default Chapter2
- Table of Contents2
- Introduction5
2 Safety and Mounting6
- Safety6
- Mounting7
3 Technical Specification8
4 Control Panel Fascias12
- Removing the Fire Detection Equipment Chassis13
5 Connecting to the Circuit Boards14
6 Detection Zone Wiring17
7 Sounder Circuit Wiring (Alarm Devices as Required by EN12094-1)17
8 Using Intrinsically Safe Barriers18
9 Connection to Monitored Inputs19
10 Connection to Extinguishant Output19
- Solenoid Wiring19
- Igniting Actuator Wiring20
- Setting up Extinguishant Monitoring Circuit20
11 Connection to Remote Control Terminals21
12 Aux 24V DC Supply Outputs (Extinguishant Modules Only)21
13 Connection to Relay Contacts22
- Common Fault Relay (on Detection Part of Control Panel)22
- Fault Relay (on Extinguishing Part of Control Panel)22
- Local Fire Relay (on Detection Part of Control Panel)22
- Fire Relay (on Detection Part of Control Panel)22
- St Stage Alarm Relay (on Extinguishing Modules)22
- 2Nd Stage Alarm Relay (on Extinguishing Modules)22
- Released Relay (on Extinguishing Modules)22
- Aborted Relay (on Extinguishing Modules)22
- Extract Relay (on Extinguishing Modules)22
14 Connection and Configuration of Status Units and Ancillary Boards23
- Adding New Status Units/Ancillary Boards24
- Removing Status Units or Ancillary Boards24
15 Configuring the Panel27
- Detection Part27
- Extinguishing Modules29
16 Panel Operation - Access Levels 1 and 235
- Normal Condition35
- Detection Section - Access Level 235
- Single Zone Fire Condition38
- Double Zone Fire Condition38
- Silence/Sound Alarms38
- Reset38
- Detection Zone Fault38
- Sounder Fault38
- Power Fault38
- System Fault - Detection Section38
- System Fault - Extinguishant Modules39
- General Fault - Detection Section39
- Lamp Test39
- Hold Condition39
- Released Condition39
- Low Pressure Switch39
- Manual Only Mode39
17 Internal Controls40
- Detection Part40
- Extinguishant Modules40
  - Terminate Extinguishant40
  - Address Switch41
18 Internal Indications41
- Detection Part41
- Extinguishant Modules42
19 Power Supply43
21 Maintenance45
23 CE Mark46
24 Commissioning Instructions47

Related product manuals

Preview: Kentec Electronics Sigma XT+

Kentec Electronics Sigma XT+

Preview: Sigma XT K11031F2

Sigma XT K11031F2

Sigma XT K11031M2

Preview: Kentec Electronics Sigma ZXT

Kentec Electronics Sigma ZXT

Preview: Sigma CP K Series

Sigma CP K Series

Preview: Kentec Electronics Syncro

Kentec Electronics Syncro

Preview: Kentec Electronics Syncro ASM

Kentec Electronics Syncro ASM

Preview: Kentec Electronics Taktis

Kentec Electronics Taktis