To Next PageTo Next Page
Need help?Do you have a question about the Kenwood 1060VR and is the answer not in the manual?
General| Power output | 100W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
|---|---|
| Frequency response | 10Hz-100kHz (+1dB, -3dB) |
| Total harmonic distortion | 0.08% (20Hz-20kHz, 8 ohms) |
| Input sensitivity | 200 mV (line) |
| Speaker load impedance | 8Ω to 16Ω |
| Video Connections | Composite |
| Dimensions | 440 x 159 x 428 mm (W x H x D) |
| Weight | 11.5 kg |
| Signal-to-Noise Ratio | 106dB (line) |
Guides on setting the AC voltage selector for correct operation based on region.
Details crucial safety guidelines to prevent hazards like electric shock and fire.
Describes the purpose of each button and knob on the receiver's front panel.
Explains the function of each button on the remote control for operating the receiver and other components.
Guides on connecting AM loop and FM indoor/outdoor antennas for optimal reception.
Details how to connect various audio sources and KENWOOD system control components.
Illustrates how to connect video sources like VCRs, LD players, and TVs to the receiver.
Explains the [SL16] and [XS8] modes for system control and how to switch between them.
Provides instructions on connecting front, center, and surround speakers, including banana plug use.
Lists the recommended impedance for front, center, and surround speakers for optimal performance.
Instructions on selecting PRO LOGIC mode and setting the center speaker mode.
How to enable the subwoofer and adjust individual speaker volume levels using test tones.
Guides on adjusting speaker volume levels using the test tone for balanced output.
Explains how to calculate and set the delay time for optimal sound staging based on room acoustics.
Details how to select DSP modes and adjust effect level, wall type, and room size for desired ambiance.
How to adjust the 'ROOM SIZE' parameter in DSP modes for different acoustic environments.
Instructions on storing stations using MEMORY and recalling them via preset numbers or P.CALL.
Details Dolby Pro Logic for theater-like surround and 3 Stereo for frontal sound field.
Step-by-step guide to register setup codes for controlling various audio/video components with the remote.
Details entering codes, checking component response, and storing the code.
How to register multiple components and finalize the setup by holding the ENT key.
Addresses no sound, blinking indicator, suggesting cord checks and volume settings.
Solves low surround sound, single-speaker issues, or humming from PHONO input.
Covers backlight flashing, subwoofer issues, or no remote operation.
