Kenwood CHEF KM010 Series User Manual

INSTRUCTIONS FOR REPAIRING THE KENWOOD CHEF KM010 & KM020 SERIES
THESE INSTRUCTIONS ARE FOR THE KM10 & 020 SERIES MIXERS
ONLY - NOT THE A901, A901E or KM200 Series
PRESS THE BUTTON ON THE SIDE AND RAISE THE MIXING HEAD.
LAY MIXER ON ITS ‘BACK’.
REMOVE THE 2 TORX SCREWS IN PHOTO ABOVE.
PRESS THE BUTTON ON THE SIDE AND PUSH THE SILVER ARM AND
ITS BRACKET DOWN INTO THE BASE.
PULL COVER DOWN FROM THE FRONT (BACK IS HOOKED UNDER THE HINGE)
PUSH COVER INTO THE BASE, EXPOSING THE CONTROLLER AND THE MOTOR.
UNPLUG THE CONNECTORS FROM THE SPEED CONTROLLER UNIT (NOTING
WHERE THEY CAME FROM AND WHICH WAY ROUND THEY ARE FITTED).
PULL THE SPEED CONTROLLER UNIT FROM ITS SLOT IN THE MIXER BODY
UNCLIP THE COVER FROM THE BACK OF THE CONTROLLER UNIT,
THE CIRCUIT BOARD AND ITS COMPONENTS WILL NOW BE EXPOSED.
2 T20 TORX FIXING SCREWS
SILVER ARM
COVER
YOU WILL NEED -
SOLDERING IRON AND SOLDER
DE-SOLDERING PUMP OR DESOLDERING WICK.
CUTTERS
T20 TORX DRIVER
PLIERS
VIEW OF THE CIRCUIT BOARD
BEFORE YOU DO ANYTHING -
TURN OFF THE POWER AND UNPLUG THE MIXER

Kenwood CHEF KM010 Series Specifications

General

Brand	Kenwood
Model	CHEF KM010 Series
Category	Mixer
Language	English

Summary

Kenwood Chef KM010/KM020 Series Repair Instructions

Safety First: Power Off and Unplug

Crucial safety step to turn off and unplug the mixer before commencing any repair work.

Disassembling the Mixer Body

Detailed steps for opening the mixer to expose internal components like the speed controller.

Speed Controller PCB Component Replacement

Preparing the Circuit Board

Instructions for desoldering and removing old components from the rear of the PCB.

Fitting New Components

Guidance on installing a new capacitor and triac, including heatsink and soldering.

Reassembly and Testing

Steps for refitting the controller, reconnecting plugs, and testing the mixer.