Kenwood DSP-100 Manual

E SPECIFICATIONS
SPECIFICATION DSP-100 ]
Mode. J3E (LSB, USB), ATAICW),
ASE(AM),
FIA(FSK)
IK and P
ovac =10%]
Power requirement |E and M type:
230VAC+10%]|
IX type: 240VAC +10%
Power dissipation Less than 30W
Operating —10'C to +50°C
temperature
(+14'F
to
+122°C)
Output frequency 455kHz
Input frequency 36.891MHz
SSB: Balanced modulation
Noait AM: Low leve! modulation
Unwanted
frequency
jerien More than 50dB
i
270X56X
281mm
Dimensions WxHxD . F
(Projections
included)
|
005/8
ve
oo
i
Weight 3 kg (6.6 lbs)
@
ACCESSORIES
Cable with connector (6-pin).
Cable with connector (13-pin)
Cable
with
connector
(Yellow).
Cable with connector (Black)...
Fuse(0.2A) (E type).
Fuse(0.2A) (M and X type)
Instruction Manual..
Waranty oard U SA, Canada and Europe version
only) .. Tea.
E INSTALLATION
Refer to the instruction manual provided with the
transceiver.
‘Downloaded
by
Amateur
Radia
Directory
ww.hamdirectory.info
@POWER switch
Press to turn the power ON or OFF.
(QPOWER indicator
Lights
when
the
POWER
switch
is
ON.
@RX switch
Depressing this switch will allow the DSP-100 to be
used during receive,
@TX
switch
Depressing this switch will allow the DSP-100 to be
used during transmit.
@CW
switch
Depressing this switch will allow the DSP-100 to be
used during CW to control the rise and decay times
of the transmitted signal.
CAR
LEVEL
contro!
Used to adjust the carrier level of the transceiver in
the CW, FSK, AM, and FM modes of operation.
@MIC GAIN control
Used to adjust the microphone gain level of the
transceiver during SSB and AM operation.
@FILTER switch (HPF) =
This 4 position control is used to select the dosred
low
frequency
cutoff
point.
GFILTER switch (LPF)
This 4 position control is used to select the desired
high frequency cutoff point.
Rear Panel
E
TAME.
bdd
dlh
@DIP switch
This switch is used to control some of the less
frequently used functions of the DSP-100, Please
refer to the chart on page 5 for further information
on this control.
@CONT IN connector
Connect the 6 pin DIN cable from this jack to the
ACC1 jack on the rear of the transceiver,
@CONT OUT connector
This connecter is used when there are two
transceivers connected together in a Master/Slave
configuration and you have separate DSP-100 units
for each transceiver. This connector is used to
eannartad tha intarfane,

Kenwood DSP-100 Specifications

General

Brand	Kenwood
Model	DSP-100
Category	Recording Equipment
Language	English