Kenwood KD-3077 User Manual

Disengage operation rod, remove cam from cut lever, and unscrew operation ass'y.

Remove E rings from the bottom side of the cut button and cam.

Remove the 3 screws from the bottom side to detach the motor.

Remove the barrier by taking out screws from the turntable case.

The return arm is fixed by 2 set screws.

Disengage operation rod, remove cam from cut lever, and unscrew mechanism ass'y.

Pause cam is supported by a bracket fixed by 2 screws.

Remove screw from tonearm support, then remove elevation shaft from bottom.

Mount return arm at illustrated angle, ensuring correct placement for proper function.

Check operation rod length and ensure tone arm returns to rest before mounting.

Hold knob vertically, then tighten screw with special pulley projection upward.

Explains KD-3070 return operation: started by cut button press, releasing center arm projection.

Explains pause mechanism operation via elevation-shaft auxiliary rod and pause lever movement.

Procedure for installing cord bushing with audio and power cords.

Details lubrication points for the return mechanism assembly using specific oils and greases.

Details lubrication points for the operation mechanism chassis, including cam and shaft.

Details lubrication points for pause/lifter mechanism, including elevation shaft and pause cam.

Details specifications for the motor and turntable platter, including drive system and dimensions.

Details specifications for the tonearm, including type, length, overhang, and tracking force.

Details specifications for the cartridge (V-39 MKII), including frequency response and stylus.

Details miscellaneous specifications like power requirement, power consumption, and dimensions.

Lists the accessories supplied with the unit, such as a headshell and EP adaptor.