Need help?Do you have a question about the Kenwood KDC-U3046 and is the answer not in the manual?
FM Tuner Section| frequency range (200 kHz space) | 87.9 MHz – 107.9 MHz |
|---|---|
| frequency range (50 kHz space) | 87.5 MHz – 108.0 MHz |
| usable sensitivity (S/N = 26dB) | 11.2dBf (1 μV/75 Ω) |
| quieting sensitivity (DIN S/N = 46dB) | 19.2dBf (2.5 μV/75 Ω) |
| frequency response (±3 dB) | 30 Hz – 15 kHz |
| signal to noise ratio (MONO) | 63 dB |
| stereo separation (1 kHz) | 40 dB |
AM Tuner Section| frequency range (Band1 MW, 10 kHz space) | 530 kHz – 1700 kHz |
|---|---|
| frequency range (Band1 MW, 9 kHz space) | 531 kHz – 1611 kHz |
| frequency range (Band2 SW1) | 2940 kHz – 7735 kHz |
| frequency range (Band3 SW2) | 9500 kHz – 10135 kHz / 11580 kHz – 18135 kHz |
| usable sensitivity (S/N = 20dB, MW) | 31 dBμ (36 μV) |
| usable sensitivity (S/N = 20dB, SW) | 32 dBμ (40 μV) |
CD Player Section| laser diode | GaAlAs |
|---|---|
| digital filter (D/A) | 8 Times Over Sampling |
| D/A converter | 24 Bit |
| spindle speed | 500 – 200 rpm (CLV) |
| frequency response (±1 dB) | 20 Hz – 20 kHz |
| total harmonic distortion (1 kHz) | 0.01 % |
| signal to noise ratio (1 kHz) | 105 dB |
| dynamic range | 93 dB |
USB Interface| USB standard | USB1.1/ 2.0 (Full speed) |
|---|---|
| maximum supply current | 500 mA |
| file system | FAT16/ 32 |
Audio Section| maximum output power | 50 W x 4 |
|---|---|
| full bandwidth power (at less than 1% THD) | 22 W x 4 |
| speaker impedance | 4 – 8 Ω |
| tone action (Bass) | 100 Hz ±8 dB |
| tone action (Middle) | 1 kHz ±8 dB |
| tone action (Treble) | 10 kHz ±8 dB |
| preout level / load (CD) | 2000 mV/10 kΩ |
| preout impedance | ≤ 600 Ω |
Auxiliary Input| frequency response (±3 dB) | 20 Hz – 20 kHz |
|---|---|
| input maximum voltage | 1200 mV |
| input impedance | 10 kΩ |
General| operating voltage | 14.4 V |
|---|---|
| maximum current consumption | 10 A |
| installation size (W x H x D) | 182 x 53 x 155 mm |
| weight | 2.9 lbs (1.3 kg) |
To Next Page
