To Next PageTo Next Page
Need help?Do you have a question about the Kenwood KR-710 and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | KR-710 |
| Category | Stereo Receiver |
| Language | English |
Step-by-step instructions for threading the dial cord on the receiver's mechanism.
Guidance on replacing power transistors, including component details and visual representation.
Alignment steps for FM discriminators, including settings and test equipment requirements.
Procedures for aligning the Voltage Controlled Oscillator (VCO) and Intermediate Frequency Transformer (IFT).
Alignment steps for AM tuning, covering IFT and tracking adjustments for different bands.
Adjusting the tuning knob for optimal noise level on the output waveform with weak signals.
Procedure for FM front-end alignment, including signal generator settings and dial pointer adjustment.
Guidance on adjusting for equal left-to-right and right-to-left channel separations.
Procedure to adjust the DC offset at the speaker terminals to zero volts.
Setting the bias voltage (idle current) for the output stage transistors to a specified mV reading.
Detailed performance specifications for the audio output, tone controls, and input sensitivities.
Performance metrics for the FM tuner, including sensitivity, selectivity, and stereo separation.
Detailed performance specifications for the audio output, tone controls, and input sensitivities.
Performance metrics for FM, MW, and LW tuners, including sensitivity and distortion.
General information including power consumption, dimensions, and weight of the receiver.
