AUTO INFORMATION AIx;
AI0; = OFF
AI1; = ON
AUTO INFORMATION - Sends a complete receiver status in the
format of the IF command (see below), when front panel controls
are changed, to the computer.
EXAMPLE - If you enter the command AI1; the auto information
function is enabled.
ANTENNA ANx;
AN1; = ANTENNA 1
AN2; = ANTENNA 2
ANTENNA - Selects either antenna port 1 or antenna port 2.
EXAMPLE - If you enter the command AN2; antenna port 2 is
selected.
DOWN DN;
DOWN - If the receiver is in VFO mode, moves the current VFO
down in frequency according to step switch. Refer to the R-5000
manual for the step sizes for each mode. If in memory channel
mode, moves the receiver down one channel.
EXAMPLE - If you enter the command DN; the frequency is
decreased 1 kHz if the receiver is in AM mode, either VFO A or
VFO B is selected, and the step switch is off.
16
To Next Page
Loading...
