REMOTE CONTROL COMMANDS
This is a list of commands that control a Kenwood R-5000 Receiver. The format and
spacing are critical. If blank spaces are needed I have pointed them out in the descriptions.
Refer to the previous section, REMOTE INTERFACE INFORMATION for an explanation on the
protocol requirements and the terminator character.
Each command is listed in the following pages using the basic outline shown below:
NAME COMMAND
LIST OF COMMAND OPTIONS (if any)
COMMAND INFORMATION - Describes what the
command does, and how to use the different options.
EXAMPLE - An example of the command using typical
options.
x
- This symbol represents a variable that the user must enter.
15
To Next Page
Loading...
