3 PREPARATIONS FOR OPERATING APRS
TH-D72A/E CONTENTS 23
Example:
144.390 MHz, the APRS operation frequency is configured for operation frequency for the data band.
Figure 3-24 Frequency
Press the [TNC] key to place a transceiver in APRS mode.
After the message “Opening TNC” appears for three seconds, “APRS” appears and the APRS data
communication capability becomes active. (Data communications take place on the data band.)
Press the [BCON] key to transmit a beacon.
The beacon is transmitted according to the method selected in Menu 3D0 (TX Beacon – Method).
3.2.14 APRS Operating Frequency
3.2.15 Placing a Transceiver in APRS mode
3.2.16 Transmitting a Beacon
To Next Page
Loading...
