TK-3201
2
GENERAL
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians
familiar with similar types of commercial grade
communications equipment. It contains all required service
information for the equipment and is current as of the
publication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment information,
the full part identification number should be included. This
applies to all parts, components, kits, or chassis. If the part
number is not known, include the chassis or kit number of
which it is a part, and a sufficient description of the required
component for proper identification.
PERSONAL SAFETY
The following precautions are recommended for personal
safety:
●
DO NOT transmit until all RF connectors are verified secure
and any open connectors are properly terminated.
●
SHUT OFF and DO NOT operate this equipment near
electrical blasting caps or in an explosive atmosphere.
●
This equipment should be serviced by a qualified technician only.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and alignment
procedures contained within.
Destination Number of CH Frequency No. / Frequency / Signalling RF power output
CH1 446.00625MHz 94.8Hz
CH2 446.09375MHz 88.5Hz
CH3 446.03125MHz 103.5Hz
CH4 446.06875MHz 79.7Hz
CH5 446.04375MHz 118.8Hz
CH6 446.01875MHz 123.0Hz
CH7 446.08125MHz 127.3Hz
E, T 16 channel CH8 446.05625MHz 85.4Hz 0.5W
CH9 446.00625MHz 107.2Hz
CH10 446.09375MHz 110.9Hz
CH11 446.03125MHz 114.8Hz
CH12 446.06875MHz 82.5Hz
CH13 446.04375MHz 132N
CH14 446.01875MHz 155N
CH15 446.05625MHz 134N
CH16 446.08125MHz 243N
TK-3201
To Next Page
