To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TK-8100 and is the answer not in the manual?
General| Frequency Range | 400-470 MHz |
|---|---|
| Channel Capacity | 128 Channels |
| Operating Temperature | -30°C to +60°C |
| Channel Spacing | 12.5 / 25 kHz |
| Modulation | 16K0F3E |
| Operating Voltage | 13.6V DC |
Essential safety precautions to prevent injury during operation and maintenance.
Describes the process and requirements for programming the transceiver.
Overview of different operating modes and their functions.
Details on using the PC for programming and communication with the transceiver.
Procedure for transferring programming data between transceivers.
Instructions for programming frequency and signaling data directly via the transceiver.
Details on connecting the voice scrambler board, including modification and pinouts.
Procedure for carefully removing the display unit from the panel.
Instructions for correctly mounting the display unit onto the panel.
Details the RF signal path through amplification and filtering stages.
Details the PLL circuit for generating local oscillator and RF signals.
Overview of the transmitter's operation and signal generation.
Describes the RF power amplification stages and filtering.
Automatic Power Control circuit for stabilizing transmission output.
Functions managed by the CPU, including controls and adjustments.
Details the power supply circuitry, including voltage regulation and protection.
Lists the necessary test equipment and their major specifications for alignment.
Procedures for adjusting components on the PCB.
Procedures for adjusting receiver performance parameters.
Adjusting receiver sensitivity based on SSG output.
Adjusting the squelch threshold.
Procedures for adjusting transmitter parameters.
Adjusting the transmit center frequency.
Setting the maximum transmit power output.
Adjusting the high power output level.
Adjusting the low power output level.
Adjusting maximum frequency deviation for wide and narrow modes.
High-level block diagram showing the main functional modules and their interconnections.
Performance specifications for the receiver section.
Performance specifications for the transmitter section.
