EasyManuals Logo

Kenwood TS-940S Instruction Manual

Kenwood TS-940S
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Button/Knob Initial Setting function Manual Reference
fcw means fully clockwise fccw means fully counterclockwise
POWER OFF (out) check external power switch
TIMER clock, ON/OF, 24 hr event 37,38
VOX/MAN MAN (out) sound-actuated transmission 24
FULL/SEMI CW break 23
MONI allows monitoring of xmit signal 8,10,14,16
DIM OFF (out) panel lights 19
SEND/REC REC (out) manual PTT 9,11,15,17
AUTO/THRU AUTO (in) antenna tuner on, NoOp while lite on 18
NAR/WIDE Normal IF or optional CW filter 10,12
ATT fccw attenuates input signal
24
AGC
SLOW for SSB
how fast gain control reacts to changes 25
METER ALC then SWR check mic w/ALC; meter function in xmit 20
NB1 & NB2 OFF (out)
auto ign / woodpecker
22
PROC PROC (in) speech processor 24
NB LEVEL 12 o'clock 22
PROCESSOR 12 o'clock increase “talk power” 24
MIC/PWR 12 oclock/ fcw transmit power for SSB 100 w 9,15 8,10,14,16
MODE: LSB 9.5 mHz USB 8-17
T-F SET split operation-spot freq 20
A/B VFO A or B 19
SPLIT
OFF
used for split operation 19
A=B idle VFO set to active VFO 19
F-LOCK tuning and band switch 19
VOICE announce freq 19
NOTCH knob OFF (fccw) reduce heterodyne on CW 22
SQL OFF (fccw) reduce background noise 9,13,15,17
PITCH OFF (fccw) CW pitch 26
AF TUNE knob OFF (fccw) 26
RIT CLEAR then OUT shift Rcv 9.99 kHz 26
XIT CLEAR then OUT shift xmit 9.99 kHz 26
NOTCH sw OFF (out) enable NOTCH knob 22
AF TUNE sw OFF (out) Opposite of NOTCH, rejects interference 26
RIT/XIT fccw/fccw incremental tuning 26
AF/RF 12 o'clock/fcw volume/gain 26
CW VBT fcw like SSB slope, but narrows both 21
SSB SLOPE HIGH fcw LOW fccw reduce IF bandwidth to reduce interference 21
numeric keypad ENT freq ENT 34
AT.T force autotune; NoOp while lite on 18
fast dial spin increases tuning rate
19
1
2
3
4
1
2
3
4

Other manuals for Kenwood TS-940S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood TS-940S and is the answer not in the manual?

Kenwood TS-940S Specifications

General IconGeneral
Receiver TypeDouble conversion superheterodyne
Antenna Impedance50 ohms
IF RejectionMore than 80 dB
ModesSSB, CW, AM, FM, FSK
Power Supply13.8 V DC
Receiver Sensitivity0.25 μV (SSB, CW), 2 μV (AM)
Image RejectionMore than 70 dB
Selectivity500 Hz (CW), 6 kHz (AM)

Related product manuals