24
EN
Normal playback
Preparing for playback
Some preparatory steps are needed before starting playback.
INPUT MODE
MD/TAPE
POWER
ON/STANDBY
POWER
(For KRF-V8060D)
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing the POWER (for
VR-6060) or POWER key and ON/STANDBY (
) (for KRF-
V8060D) keys.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
VIDEO3 or DVD/6CH jacks, make sure that the input mode setting is
correct for the type of audio signal to be used. 9
Selecting MD/TAPE
Select the source name corresponding to the component connected
to the MD/TAPE jacks. The initial factory setting is “MD”. To change
the source to “TAPE,” follow the steps below:
Hold down the MD/TAPE key for more than 2 seconds.
• The source indication changes to “TAPE”.
• To return to the original indication, repeat procedure above.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
A ON : Sound from the speakers connected to the
SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the
SPEAKERS B
terminals on the rear panel. No sound will be heard from
the subwoofer.
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all
playback modes.
The indicator for the speakers
you want to use should be lit.
L
SL S SB SR
C R
SP MUTE
OPTICAL 6CH INPUT
COAXIAL ANALOG 96kHzfs
CINE
A B CLIP
AUTO DETECT
SW
LFE
• Selecting “6CH INPT” by pressing the INPUT MODE key, whereby
“DVD/6CH” is the input source will cause SPEAKERS A to be selected
automatically.
Listening to a source component
VOLUME CONTROL
RCV. VOL. /
INPUT SEL.
Input Selector AV AUX
1
Use the Input Selector and AV AUX keys to select the
source you want to listen to.
The input sources change as shown below:
Selecting a source using each key.
1 “DVD/6CH”
2 “CD/DVD”
3 “PHONO”
4 “TUNER”
5 “VIDEO1”
6 “VIDEO2”
7 “VIDEO3”
8 “MD/TAPE”
9 “AV AUX”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or RCV. VOL. +/
-
keys to
adjust the volume.
•VR609/20-28/EN 10/24/01, 10:36 PM24
To Next Page
Loading...
Need help?
General
