Kenwood VRS-N8100 User Manual

AUDIO VIDEO SURROUND RECEIVER
VRS
-
N8100
INSTRUCTION MANUAL
KENWOOD CORPORATION
About the supplied remote control
Compared to standard remote controls, the remote control supplied with this receiver has
several operation modes. These modes enable the remote control to control other audio/video
components. In order to effectively use the remote control it is important to read the operating
instructions and obtain a proper understanding of the remote control and how to switch its
operation modes (etc.).
Using the remote control without completely understanding its design and how to switch the
operation modes may result in incorrect operations.
Quick Start Reference
Please read the following pages so that you can enjoy the surround sound at the best
condition.
(These pages give shortcut explanations on how to connect the speaker system to the
receiver, set up the speakers and play a source.)
"Let's play DVD video software" *(
Preparations
Receiver Operations
Remote Control
Additional Information
Network Operations
B60-5489-00 00 MA (K, P, E, X) 0403
*5489/01-08/EN 04.7.30, 10:39 AM1

Kenwood VRS-N8100 Specifications

General

Channels	7.2
Network Connectivity	Ethernet, Wi-Fi
USB Ports	1
3D Support	Yes
Dolby Atmos	Yes
DTS:X	Yes
HDCP Version	2.2
Zone Output	Zone 2
Frequency Response	10 Hz - 100 kHz (+1 dB, -3 dB)
Signal-to-Noise Ratio	100 dB
Input Sensitivity	200 mV
Speaker Impedance	6-16 ohms
Audio Formats Supported	Dolby Digital, DTS
Streaming Services	Spotify, Deezer, TIDAL
HDMI Inputs	6
HDMI Outputs	2
4K Support	Yes
Bluetooth	Yes
AirPlay	Yes
Total Harmonic Distortion	0.08%
Power Output	100W per channel (8 ohms, 20Hz-20kHz, 0.08% THD, 2 channels driven)