KERN CXB - Call-Up; Count with Tolerance Control - Fill to Target; Set Tolerance Value for Target Number of Pieces

9.4.2 Call-up
When the reference weight is required at a later point in time it can be called by
pressing the key and entering the relevant storage location number.
Press button
PlSET�

a
PRE-
TARE
M+

Enter memory location (0 - 9) via number keys and the stored reference weight will
appear.
0.0��
a
PRE-
TARE

100�
0
M+

9.5 Count with tolerance control - Fill to target
This function can be used to program a target number of pieces or target weight.
Reaching the target value is indicated by an audio-visual signal.
9.5.1 Set tolerance value for target number of pieces
[
-0.TX-
] is flashing in reference weight window.
Press button
-----��
a
PRE-
TARE
0�
300
M+

Last value stored
Use number keys to enter desired target number of pieces
-----��
a
PRE-
TARE
100�
Entered target value.
Corrections possible by
pressing key
300
M+

Last value stored
CXB/CXP-BA-e-1417 29