KERN FTC

Table of contentsFTC-BA-e-0720
3User manual ME-Nr.22017145 01/07
Table of contents
Page
1 Introduction .....................................................................................5
1.1 Safety instructions .............................................................................5
1.2 Description ......................................................................................6
1.3 Putting into operation ......................................................................10
2 Operation ......................................................................................13
2.1 Switching on and off .......................................................................13
2.2 Zeroing / Zero point correction ..........................................................13
2.3 Simple weighing .............................................................................13
2.4 Weighing with tare ..........................................................................14
2.5 Calling up the gross weight and tare value .........................................15
2.6 Displaying weight values with a higher resolution ...............................15
2.7 Displaying the capacity available ......................................................15
2.8 Dynamic weighing ..........................................................................15
2.9 Printing results ...............................................................................16
2.10 Switching scales .............................................................................16
2.11 Cleaning ........................................................................................17
3 Counting .......................................................................................18
3.1 Counting parts into a container .........................................................18
3.2 Counting parts out of a container ......................................................19
3.3 Counting with variable reference quantity ...........................................19
3.4 Counting with minimum accuracy ....................................................19
3.5 Reference optimization ....................................................................20
3.6 Counting with automatic reference determination ................................20
3.7 Counting with two scales .................................................................20
4 Settings in the menu ......................................................................23
4.1 Operating the menu ........................................................................23
4.2 Overview .......................................................................................25
4.3 Scale settings (SCALE) ....................................................................28
4.4 Application settings (APPLICATION) ..................................................32
4.5 Terminal settings (TERMINAL) ..........................................................34
4.6 Configuring interfaces (COMMUNICATION) .........................................35
4.7 Diagnosis and printing out of the menu settings (DIAGNOS) ................38
5 Interface description ......................................................................39
5.1 SICS interface commands ................................................................39
5.2 TOLEDO Continuous mode ..............................................................42
6 Event and error messages ..............................................................44
7 Technical data and accessories ......................................................46
7.1 Technical data ................................................................................46