GAB/GAS/FAB-BA-e-0720
20
7.2 Operation
7.2.1 How to turn on/off balance
1. To turn on the balance press the ON/OFF key.
The balance will carry out a self-test
2. The balance is ready for weighing when the
weight display appears.
3. To turn the balance off, keep the ON/OFF key
pressed down for 1-2 seconds.
7.2.2 Resetting balance to zero
Environmental influences can lead to the exact figure of “0.00“ not being displayed in
spite of an empty weighing dish. It is, however, possible to reset your balance to zero
at any time and thus ensure that weighing really does commence at zero. Setting to
zero when a weight is applied is only possible within a certain type-dependent range.
In the event that the balance cannot be reset to zero with an applied weight, this
range has been exceeded.
1. If the balance despite of uncharged weighing
plate does not show exactly zero, press the
Reset key.
2. Your balance will be set to zero after a short
standby time.
OK
OK
OK
To Next Page
Loading...
Need help?
General
