104
770/GS/GJ-BA-defsi-0023
4.5 Counting
Counting Code 2 1 4
Symbol displayed:
The counting program allows automatic conversion of weights into piece counts based
on a reference sample weight. A weight readout is stored as a reference quantity
(factory setting: 10 pcs = pieces).
Displaying the Reference Sample Quantity
If the weighing pan is unloaded, the set reference sample quantity (pcs) briefly appears
in the weight display after having pressed the
F
key.
Changing the Reference Sample Quantity
The reference sample quantity can be changed in cycles, by you. Choose from the
following settings: 5, 10, 20, 50 and 100.
To activate this function:
Hold down the
F
key for more than 2 seconds until “
rEF ...
pcs
“ appears on the display.
To change the setting:
Briefly press the
F
key.
To store the quantity:
Hold down the
F
key for more than 2 seconds.
When you exit the reference storage mode, “
Err 22
“ may briefly be displayed. This
means that the new reference value has been stored.
This setting is not cancelled by the reset function 9--1
o
!
Toggling between the Piece Count (pcs) and Weight (g)
After placing the sample on the weighing pan, you can toggle between the piece count
and the respective weight readout by pressing the
F
key.
To Next Page
Loading...
Need help?
General
