KERN TCKE 300-3-A Operating Instruction

22 CKE-BA-e-2132
Ch-hi
The audible signal sounds
when the target number of
pieces is higher than the
preset tolerance range
off
The audible signal is off
Slow beep
Slow
Standard
beep
Standard
Fast beep
Fast
Cont. beep
Continuous
Limit determination:
 In the application menu, display the <check> menu item and confirm, pressing
TARE.
 The <limit> symbol will be displayed. Confirm with TARE; the <limupp>
symbol will be displayed.
 Confirm with TARE; wait until the window for value entry in the numerical form is
displayed where you can enter the upper limit value <limupp>. Enter the upper
limit value of the target number of pieces (for introducing the numerical value see chap-
ter
3.2.2)) and confirm, pressing TARE. The <limupp> symbol will be dis-
played.
 Confirm with TARE; wait until the window for value entry in the numerical form is
displayed where you can enter the lower limit value < limlow >. Enter the lower
limit value of the target number of pieces (for introducing the numerical value see chapter
3.2.2) and confirm with TARE. The < limlow > symbol will be displayed.
Tolerance check start:
 Determine the mean weight of an individual part, see chapter 9.
 Place the weighed material and, based on the tolerance symbols / audible signal,
check if the weighed material belongs to the preset tolerance range.
Weighed material
below
the preset tolerance
Weighed material
in the preset tolerance
Weighed material
above
the preset tolerance

KERN TCKE 300-3-A Specifications

General

Brand	KERN
Model	TCKE 300-3-A
Category	Scales
Language	English