Kernau KFC 6008 GE X - Operation of Gas Outflow Protection; Electronic Programmer

EN
60

Thecookersareequippedwiththeautomaticoutflowprotectionsystem,thissystemcutthesupply
ofgaswhentheflamedisappears.
Thissystempreventfromoutlflowofgaswhentheflameonburnerwilldisappears,e.g.whenthe
burnerisprimed.
Re-ignitingofburnerrequiresuserintervention.


Aftertheconnectingtopowersupplysystemorre-connecting
displayshowsblinking„0.00”.
• PressandholdOKbutton(oratonce</>buttons)
untilondisplayshowup symbol, and the dot
belowthissymbolwillbeblinking.
• In7secsetthecurrenttimeusingthe</>buttons.
After7secfromsettingthetime,newdatawillbesaved,and
thedotwillstopblinking.
Thetimeadjustementcanbemadelaterbypressingatoncethe</>buttonsmwhilethedotbelowthe
symbolwillbeblinking,thecurrenttimecanbeadjusted.
 
Theovencanbestaredafterthesymbolshowupondisplay.

The timer may be stared at any time, without impact on the working process other programator
functions.Theadjustmenttimeisfrom1minutetill23hoursand59minutes.

• PresstheOKbuton,ondisplaywillblink„bell”symbol.
• Setthetimeoftimerwith</>buttons,thedisplaywillshowthetimeoftimerandactive
workfunction„bell”,afterthesettimehaselapsedthesoundsignalwilturnonandthe„bell”
symbolwillblink.
• Pressandholdthebuttons</>orMENUforturnoffthesoundsignal,the„bell”signalwill
disappear,andthedisplayshowthecurrenttime.
 
Soundsingnalwillturnoffafter7minutesifnosensorsaretouched.
OK
OK Operating mode selection button
>
Plus button
<
Minus botton
Ready to work indicator
Timer indicator
Duration of work indicator