Key Digital KDUPS52USB - Specifications

521 East 3
rd
Street Mt. Vernon, NY 10553 • www.keydigital.com
Rev 1.1 – Sep, 2021
31
-- 02 : HDMI2, LINK = OFF --
-- --
-- Video Output Status (D=Disable, E=Enable) --
-- HDMI Output : IN = 01, OUT = ON , V/MUTE = D, LINK = ON , DBG = OFF --
-- HDBT Output : IN = 01, OUT = ON , V/MUTE = D, LINK = ON , DBG = OFF --
-- LRM = OFF --
-- --
-- Display Output Status (CEC Control) --
-- HDMI Output : TV = ON , A/V MUTE = Disable, A/MUTE = Disable --
-- HDBT Output : TV = ON , A/V MUTE = Disable, A/MUTE = Disable --
-- --
-- Audio Output Status --
-- Audio Output : IN = Video 01 , Balanced = Enabled, PCM = Enabled --
-- AMP220 Mode = OFF, MIC Mode = OFF --
-------------------------------------------------------------------------
Specifications
Technical
• AV Inputs: 2x HDMI, 1x Display Port, 1x USB-C,
• AV Outputs: 1x HDBaseT RJ45, 1x HDMI, 1x Analog Audio on 6-pin terminal block, 1x Digital Audio on
PCM RCA
• DDC Signal (Data): Input DDC Signal: 5 Volts p-p (TTL)
• HDMI Video/Audio Signal: Input Video Signal: 1.2 Volts p-p
• Display Port Video/Audio Signal: Input Video Signal: 1.2 Volts p-p
• USB-C Video/Audio Signal: Input Video Signal: 1.2 Volts p-p
• RJ45 Connectors: Shielded Link Connector, 2x HDBaseT, 1x LAN
• Unit Control: TCP/IP on RJ45, Bi-directional RS-232, Serial IR, IR sensor, USB Micro
• RS-232 Connector: 1x 3-pin terminal for unit control, 2x 3-pin terminal for pass-thru to/from HDBaseT
Input and HDBaseT output
• IR Connectors: 1x IR Sensor, 1x 2-pin terminal for unit control, 1x 2-pin terminal for IR pass-thru to
HDBaseT Input, 1x 3.5mm mono for IR input pass-thru to HDBaseT Output, 1x 3.5mm mono for IR
output pass-thru from HDBaseT Output
• RS-232 Connector: 3-pin phoenix terminal