Keyscan NETCOM2 - Page 14

Keyscan Inc. A Member of the Kaba Group
14
8. Once you reach the Change Setup: prompt, Press 0 for Server setup parameters and
enter the following values for 0 Server (Keyscan values)
0 Server (User Defined Values)
 IP Address: Enter the User Static IP Address, and press the Enter key.
 Set Gateway IP Addr: Press the Y key for yes or the N key for no.
 If Y was selected in the previous step, then enter the Gateway IP address, and
press the Enter key.
 Netmask: Specify the Netmask by entering its list number (the number on the
left opposite the Netmask) and press the Enter key.
3 = 255.255.255.248
4 = 255.255.255.240
5 = 255.255.255.224
6 = 255.255.255.192
7 = 255.255.255.128
8 = 255.255.255.0 (Default)
9 = 255.255.254.0
10 = 255.255.252.0
11 = 255.255.248.0
12 = 255.255.240.0
13 = 255.255.224.0
14 = 255.255.192.0
15 = 255.255.128.0
16 = 255.255.0.0
17 = 255.254.0.0
18 = 255.252.0.0
19 = 255.248.0.0
20 = 255.240.0.0
21 = 255.224.0.0
22 = 255.192.0.0
23 = 255.128.0.0
24 = 255.0.0.0
 Set DNS Server IP addr: Press the N key for no.
 Change telnet config password: Press the N key for no.
9. After completing the Server parameters, press 1 for Channel 1 setup parameters and
enter the following Keyscan values. Press the Enter key after each entry.
1 Channel 1 (Keyscan Values)
 Baudrate = 9600 (Must match ACU settings)
 I/F Mode = 4C
 Flow = 00
 Port No. = 3001
 ConnectMode = C0
 Send ‘+++’ in Modem Mode = N
 Show IP addr after ‘RING’ = N
 Remote IP Address = 000.000.000.000
 Remote Port = 0
 DisConnMode = 00
 FlushMode = 80
 Pack Cntrl = 01