Installation Note N9010-90067 9
Option EXM, External Mixing Upgrade Kit
Option PRC
1. Disconnect the instrument from ac power.
2. Refer to Figure 2, “Bail Handle Removal,”. Using the T-20 driver, remove the four screws (two
on each side) (1) that hold the bail handle (2) to the front frame.
Figure 2 Bail Handle Removal
3. Using the T-20 driver, remove the four screws (two on each side) (6) that hold the strap
handle plugs (5) in place.
To Next Page
Loading...
