Keysight Technologies FieldFox N9938A Service Guide

Keysight FieldFox Handheld Analyzers Service Guide 149
Repair and Replacement Procedures
Removing and Replacing the Measurement Group Assemblies
15.Remove the System board to FPIB cable (W14) from the old A5 System
board and install it on the new board.
16.For N995xA and N996xA models, replace the top panel assembly. Refer to
“Removing and replacing the RF Top Panel Assembly” on page 138.
17.Reinstall the I/O side panel. Refer to “Replacing the I/O Side Panel, Doors,
and Gasket” on page 120.
18.Perform the steps under “Final Assembly Procedure” on page 164.

Keysight Technologies FieldFox N9938A Specifications

General

Brand	Keysight Technologies
Model	FieldFox N9938A
Category	Measuring Instruments
Language	English