Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 193
Programming the Status Register System
Status Groups
Data Questionable Frequency Status Group
The Data Questionable Frequency Status Group is used to determine the
specific event that set bit 5 in the Data Questionable Condition Register. This
group consists of the Data Questionable Frequency Condition Register, the
Data Questionable Frequency Transition Filters (negative and positive), the
Data Questionable Frequency Event Register, and the Data Questionable
Frequency Event Enable Register.
Some of the bits in this status group do not apply to all models, and return
zero when queried. See Table 4-6 on page 194 for more information.
Some signal generator models may use only a subset of the status
registers shown.
To Next Page
Loading...
Need help?
General
