Keysight CXA N9000A - Page 330

6 System Functions
System
Time
Enables you to configure the time of the scheduled task. The SCPI command to configure the date and time
parameters of the scheduler is the same; however, they each have their own front panel-control.
Key Path
System, Alignments, RF Preselector, Schedule Setup, Date/Time
Notes See "Date/Time " on page 329 .
For model N9038A only.
Preset This is unaffected by Preset but is set to Current date and 00:00:00 on a “Restore System Defaults-
>Align”.
State Saved No
Initial S/W Revision A.08.00
Recurrence
Enables you to configure the scheduler to run the task recurrently on a scheduled date and time. You can
schedule it to run daily, weekly or alternate weeks.
Key Path
System, Alignments, RF Preselector, Schedule Setup
Mode All
Remote Command
:CALibration:RFPSelector:SCHeduler:RECurrence DAY|WEEK|OFF
:CALibration:RFPSelector:SCHeduler:RECurrence?
Example :CAL:RFPS:SCH:REC DAY
Notes For model N9038A only.
Preset This is unaffected by Preset but is set to OFF on a “Restore System Defaults->Align”.
State Saved No
Range DAY|WEEK |OFF
Initial S/W Revision A.08.00
Every N Weeks
Enables you to configure the scheduler to run the task on a day in every number of week’s duration.
Key Path
System, Alignments, RF Preselector, Schedule Setup, Recurrence
Initial S/W Revision A.08.00
N of Weeks
Enables you to set the number of weeks that the scheduler will wait to trigger a task.
Key Path
System, Alignments, RF Preselector, Schedule Setup, Recurrence, Every N Weeks
330 EMI Receiver Mode Reference