Keysight CXA N9000A - Normal Marker State (Remote Command Only)

8 Frequency Scan Measurement
Marker
"Normal Marker Y Axis Value (Remote Command Only)" on page 415
"Delta Marker State (Remote Command Only)" on page 416
"Delta Marker X Axis Value (Remote Command Only)" on page 416
"Delta Marker Y Axis Value (Remote Command Only)" on page 416
Normal Marker State (Remote Command Only)
Toggles the Normal marker state on and off.
Remote Command
:CALCulate[1]|2:MARKer[1]|2|...|4[:STATe] ON|OFF|1|0
:CALCulate[1]|2:MARKer[1]|2|...|4[:STATe]?
Example CALC:MARK4 ON Turn on maker 4 in Normal mode.
Notes This SCPI is Meas Local and Context Sensitive. This SCPI alias to :CALC:FSC:MARK[1]|2|3|4:MODE
POS.
Preset OFF
Initial S/W Revision A.07.00
Normal Marker X Axis Value (Remote Command Only)
Sets the selected marker to Normal mode, and sets/ gets the marker X Axis values.
Remote Command
:CALCulate[1]|2:MARKer[1]|2|...|4:X <value>
:CALCulate[1]|2:MARKer[1]|2|...|4:X?
Example CALC:MARK3:X 3e4 Turn on maker 3 in Normal mode, set the marker frequency to 30 kHz.
CALC:MARK3:X? Turn on maker 3 in Normal mode and query the X axis value.
Notes This SCPI is Meas Local and Context Sensitive. This SCPI alias to :CALC:FSC:MARK[1]|2|3|4:MODE
POS; :CALC:FSC:MARK[1]|2|3|4:X?
Preset 9.91E+37
Initial S/W Revision A.07.00
Normal Marker Y Axis Value (Remote Command Only)
Sets the selected marker to Normal mode, and returns the marker Y Axis values.
Remote Command
:CALCulate[1]|2:MARKer[1]|2|...|4:Y?
Example CALC:MARK3:Y? Turn on maker 3 in Normal mode and query the Y axis value.
Notes This SCPI is Meas Local and Context Sensitive. This SCPI alias to :CALC:FSC:MARK[1]|2|3|4:MODE
POS; :CALC:FSC:MARK[1]|2|3|4:Y?
Initial S/W Revision A.07.00
EMI Receiver Mode Reference 415