Electronic Calibration Modules Reference Guide 2-9
Preparing ECal for Use
Options
Options
N755xA Options
Where "x" represents the connector type (i.e., "N" for 50Ω Type-N and "3" for
3.5 mm:
— Option xFF, configures the module with female-to-female connectors.
— Option xMM, configures the module with male-to-male connectors.
— Option xMF, configures the module with male-to-female connectors.
N4431D Options
— Option 010 configures the model with 3.5 mm –f– and 020 configures the
module with Type-N 50 ohm -f- connectors on all ports.
— Option UK6 adds a commercial calibration certificate with measured data.
For more, refer to “N4431D Modules (RF Four-Port)” on page 1-7
N469xD Options
Where:
— Option F0F, configures the module with female-to-female connectors.
— Option M0M, configures the module with male-to-male connectors.
— Option M0F, configures the module with male-to-female connectors.
N4432D Options
— Option 020 configures the module with Type-N 50 ohm -f- connectors on
all ports.
— Option UK6 adds a commercial calibration certificate with measured data.
For more, refer to “N4432D and N4433D Modules (Microwave Four-Port)”
on page 1-14
N4433D Options
— Option 010 configures the module with 3.5 mm -f- connectors on all ports.
— Option UK6 adds a commercial calibration certificate with measured data.