1 Introduction
Preparing Your Multimeter
10 U1231A/U1232A/U1233A User’s Guide
Alerts and warnings during measurement
Voltage alert
Your multimeter provides a voltage alert for voltage
measurements in both autoranging and manual range modes.
The multimeter starts beeping periodically once the
measured voltage exceeds the alert value (regardless of
polarity) set in the Setup menu.
By default, this feature is turned off. Be sure to set the alert
voltage according to your test requirements. To change the
alert voltage level, refer to
“Enabling and changing the
voltage alert level” on page 86.
Hazardous voltage indication
The multimeter will also display the hazardous voltage ( )
symbol as an early precaution when the measured voltage is
equal to or greater than 30 V in all voltage measurement
modes.
For your own safety, please do not ignore the voltage alert. When the
multimeter cautions you with a voltage alert, you are advised to take
note of the existence of high voltage and pay closer attention when
performing measurements.
To Next Page
Loading...
